E2E2-X10D1

What type of sensor is this?

This model is a long-barrel inductive proximity sensor designed to detect metal targets without physical contact. The E2E2-X10D1 is a DC 2-wire, shielded, normally open sensor with an M30 threaded body.

What is the sensing distance?

The rated sensing distance is 10 mm, with a tolerance of plus or minus 10%. The recommended set distance is 0 to 8 mm.

Is it a shielded or unshielded design?

It is a shielded design. That helps provide a more controlled sensing field and can make mounting in metal easier when the specified clearances are followed.

What electrical configuration does it use?

This is a DC 2-wire sensor. Its power supply voltage is 12 to 24 VDC nominal, with an operating range of 10 to 30 VDC and ripple up to 10% peak-to-peak.

What output behavior does it have?

This version is normally open. When a target enters the sensing range, the control output turns on. It also includes a red operation indicator and a green setting indicator.

What load can it switch?

The control output switching capacity is 3 to 100 mA. Residual voltage is 3 V max. at a load current of 100 mA with a 2 m cable.

What materials can it detect?

It is intended for ferrous metal sensing. It can also respond to non-ferrous metals, but the sensing distance is reduced compared with iron.

What target size is used for the rated sensing specification?

The standard sensing object for this model is an iron target measuring 30 x 30 x 1 mm. Rated sensing performance is based on that reference target.

What is the response frequency?

The response frequency is 100 Hz. This value is given as an average under specified test conditions.

What is the body size and mounting thread?

It has an M30 x 1.5 threaded brass case. The mounting hole dimension is 30.5 mm with a plus 0.5 mm, minus 0 mm tolerance.

Does it come with a cable?

Yes. It is a pre-wired model with a standard 2 m cable. For the M30 size, the cable is a 2-conductor vinyl-insulated round cable with 0.5 mm2 conductor cross section.

Can the cable be extended?

Yes. The cable can be extended up to 200 m when installed in a separate metal conduit.

What environmental rating does it have?

The sensor is rated to IEC IP67 and is also described as having in-house oil resistance. The operating and storage temperature range is -25 to 70 degrees C, with humidity from 35% to 95% non-condensing.

What indicators are fitted on the sensor?

This model has two indicators: a red operation indicator and a green setting indicator. The green indicator helps show the usable setting range.

Are mounting hardware items included?

Yes. Each sensor is supplied with two clamping nuts and one toothed washer.

What installation points should be checked during mounting?

For best results, the mounting arrangement should take surrounding metal and nearby sensors into account. The specified clearances for shielded M30 DC 2-wire models should be followed, and the recommended tightening torque for the M30 body is 180 N·m.

What are the main body materials?

The case is brass, the sensing surface is PBT, the clamping nuts are nickel-plated brass, and the toothed washer is zinc-plated iron.

Where is this sensor commonly used?

It is commonly selected for non-contact metal detection tasks in industrial equipment, such as position sensing, presence detection, and end-of-travel confirmation where a robust threaded inductive sensor is needed.