DFM-12-10-P-A-GF

What type of actuator is this component?

It is a guided pneumatic actuator with a yoke mechanism and an integrated sliding guide, designed to move a load in a controlled linear motion while resisting side loads and moments better than a standard cylinder.

What stroke length does it provide?

The stroke length is 10 mm.

What is the piston diameter?

The piston diameter (bore) is 12 mm.

Is it single-acting or double-acting?

It is double-acting, meaning compressed air is used for both extension and retraction.

What operating pressure range is suitable?

The operating pressure range is 2 to 10 bar (0.2 to 1.0 MPa).

What force can it produce at 6 bar?

At 6 bar, the theoretical force is 68 N advancing (extending) and 51 N retracting. Actual usable force will vary with friction, guidance load, fittings, and application conditions.

What is the maximum speed?

The maximum speed is up to 0.8 m/s, depending on load, flow control, and installation conditions.

What payload and moment loads can it handle?

For this size and stroke, the maximum payload is specified as 28 N at a defined centre-of-gravity distance xs of 25 mm, and the maximum permissible torque load Mx is 0.6 Nm (stroke-dependent). If your load is offset or you have external moments, it is best to verify against your application geometry.

What are the overall dimensions and weight?

The body size is approximately 74 x 58 x 26 mm, with a product weight of about 344 g and a moving mass of about 172 g.

What pneumatic port size does it use?

It uses M5 pneumatic connections.

Can it be mounted in any orientation?

Yes. The mounting position is specified as any, provided the application stays within the allowable loads and you account for the effects of gravity on the payload.

Does it include cushioning at the end positions?

Yes. It uses elastic cushioning rings/pads at both ends to soften end-stop impacts.

Can I use position sensing with this actuator?

Yes. It is designed for position sensing via proximity sensors (as indicated in the product features). Ensure the sensor type and mounting arrangement match your sensing requirement.

What compressed air quality and temperature range are recommended?

The operating medium is compressed air to ISO 8573-1:2010 class [7:4:4]. Ambient temperature range is -20 °C to +80 °C.

Is operation with lubricated air permitted?

Yes. Operation with oil lubrication is possible; if lubrication is used, it is typically expected to be continued for subsequent operation to maintain consistent performance. This component is commonly referenced as DFM-12-10-P-A-GF in build documentation.